Shkolotron & Ultrasonic
I’ve been trying to pull a clean 32kHz sine out of a custom op‑amp design, but the output keeps spiking a bit—any thoughts on how to tweak the filter to get a truly flat response?
If the 32 kHz sine is still spiking, the op‑amp’s slew rate or the feedback tolerance is probably the culprit. Swap to a device with at least a 1 V/µs slew, and use 1 % resistors in a tight, symmetrical RC network so the poles sit cleanly between 20 kHz and 40 kHz. Keep the source and load matched; a thin 2 AWG cable can add 20 Ω in series and throw the curve off. Add a 0.1 µF bypass capacitor right at the rails—tiny ripple can create those spikes. With a perfectly matched, higher‑order active filter the waveform will ride straight out, no jagged tails.
Yeah, looks like the op‑amp’s just being dramatic. I’ll swap to a higher slew and tighten the resistor tolerances—time to see if that 32 kHz stays in line.
Great move—high‑slew op‑amps are the gospel when you want the sine to glide like a clean wave front. Just make sure the resistor ladder is a monastic shrine: 1 % parts, gold‑plated leads, no stray inductance from routing. And hey, if you see that pesky phase lag, try a 100 nF shunt on the output; it’ll swallow the micro‑tremors before they hit the headphones. Once the curve is perfectly flat, the reverb tail will taste like pure liquid nitrogen—no distortion, just sheer purity.
Sounds like you’re building a symphony of clean sinusoids—let’s keep that phase in check, run that 100 nF shunt, and watch the waveform glide. If the head‑phones still sputter, we’ll blame the cable. All right, go on and make that “pure liquid nitrogen” sound.
If the head‑phones still sputter after the 100 nF shunt, it’s almost certainly the cable. Use a short, shielded 18‑AWG wire, keep the length under 1 meter, and make sure the impedance matches 32 Ω. Once the cable is clean, the sine will glide like a whisper of ice—no sputter, just crystal.
Nice, keep the cable short, shielded, 18‑AWG, under a meter, 32 Ω match—then the sine should glide smooth, no sputter. If it still hiccups, drop a ferrite bead or swap the cable entirely. Give it a test and let me know if the whisper of ice comes through.
Sounds like a solid plan—give it a quick run, and if the ice‑whisper still slips, we’ll add that ferrite or change the cable again. Let me know what the wave looks like once you’ve tuned it.