FrostGlider & Tharnell
Hey Tharnell, I’ve been tweaking the edge angle on my new carving skis, trying to shave a few degrees off the turn time. Got any thoughts on how to optimize the edge geometry without overcomplicating the design?
Sure thing. Keep it simple: an edge angle of about 15 to 20 degrees works for most carving skis. Don’t go crazy sharpening just to shave a degree off the turn time – it’ll make the edges dull fast and mess up the balance. Stick to a single angle on both sides, check that the binding angles line up, then test on a smooth run. If you feel the turns are still sluggish, tweak the camber a bit instead of hunting for micro‑angles. Trust the metal, not the fancy software.
Sounds solid—15 to 20 is a good sweet spot. Just make sure the binding angles stay true, and when you test, look for that clean slide on the base, not just speed. If it feels sluggish, a slight camber tweak will give you better lift and edge hold. Keep it tight, keep it consistent, and you’ll hit those turns with authority.
Just eyeball the bindings before you hit the slope – if they’re skewed, the edge angle won’t matter. After a run, feel the base; if it feels like it’s skidding instead of carving, tighten the camber a touch. Keep the numbers low and stick with what the metal says. That’s the only way to avoid over‑engineering.
Right on point—no fancy math, just the feel of the metal. Once the bindings are set, a quick run and a quick tweak to the camber can make all the difference. Stick to what feels solid, and you’ll carve like a pro.
Yeah, if the bindings sit flat and the base slides clean, you’re good. Don’t let the machine talk to you more than the ski does. Keep it tight, keep it simple.
Exactly. Keep the focus on the feel, not the numbers. Stick to clean edges, tight bindings, and that’s how you stay in the groove.
Got it. Keep the edges sharp, the bindings tight, and listen to what the ski says. That's all you need.
You got it. Stay sharp, stay tight, and trust the feel of the ski. That’s the recipe for shredding.
Alright, hit the slopes. If anything starts to fall apart, I’ll be the one with the spare parts.
Got it, let’s hit the slopes. Keep your eyes on the line, stay tight, and if anything breaks, grab those spare parts and get it back in shape. No excuses.
Keep the metal clean, the bindings locked, and don’t fuss over the numbers. If a part goes wonky, just swap in the right processor from the stash and you’ll be back in the groove. No fuss, just function.
Sounds like a plan—clean metal, tight bindings, and a quick swap if anything goes off. We’ll be back on the run in no time.