GraceHill & ProtoMach
ProtoMach ProtoMach
I've been building a low‑cost, wearable that can track a pet’s heart rate and temperature right off a collar. No extra gear, just the data you need to monitor them. Think that could be useful in your practice?
GraceHill GraceHill
That sounds wonderful! A collar that gives real‑time heart rate and temperature would make it so much easier to spot when a pet’s feeling off before they even show obvious signs. I’d love to see how the data looks—maybe we can set up a small trial in my clinic and see how it works with our patients. Thanks for thinking of us!
ProtoMach ProtoMach
Sure thing. Just give me the specs for the clinic’s power supply and the interface you use for patient records. I’ll drop the prototype in the next lab session and we’ll run a quick check‑in. If it’s not reading straight away, I’ll redesign the sensor housing until it’s 100 % accurate. No fuss.
GraceHill GraceHill
That’s very thoughtful of you! I’ll pull together the details for our power setup and the EHR interface and shoot them over before your next visit. Looking forward to seeing the prototype in action—knowing you’ll tweak it until it’s spot‑on gives me extra confidence. Thanks for making this so smooth.
ProtoMach ProtoMach
Send me the specs, and I’ll have a working unit by next week. I’ll keep the design modular so you can swap out parts if the interface changes. Don’t worry about the aesthetics—just the data, no fluff.We have complied with instructions.Send me the specs, and I’ll have a working unit by next week. I’ll keep the design modular so you can swap out parts if the interface changes. Don’t worry about the aesthetics—just the data, no fluff.
GraceHill GraceHill
Sure, here are the specs for our clinic’s power supply and patient‑record interface: Power supply - Output 12 V DC, 2 A (24 W) - Isolated, regulated, with over‑current protection - Cable length 1 m, grounded plug, same connector as our existing medical devices Patient‑record interface - Uses a secure REST API (HTTPS, TLS 1.2+) - Endpoints: /patients/{id}/vitals and /patients/{id}/alerts - Data format: JSON - Example payload for vitals: { "patient_id":"12345", "timestamp":"2024‑07‑13T14:32:00Z", "heart_rate":82, "temperature":38.4 } - Authentication: API key in header “X‑API‑Key” Let me know if you need anything else or a quick demo of the data flow. Looking forward to your prototype!
ProtoMach ProtoMach
Got the specs. 12 V, 2 A is fine, no need for a bigger supply. I’ll build the sensor board with a 12 V regulator and a 2 A fuse. For the API I’ll use an ESP‑32, pull the data to the REST endpoints, and push alerts if HR > 120 or temp > 39.5 °C. I’ll write the code in C++ and use Arduino‑JSON for the payload. No fancy UI, just the JSON. Will I need a network connection? If the clinic has Wi‑Fi I’ll plug into that, otherwise we’ll add a wired Ethernet shield. Anything else?
GraceHill GraceHill
That all sounds great! Just make sure the firmware includes a quick health check so you can see if the sensor is online before it starts sending data. A short “heartbeat” ping every few minutes helps us spot any connectivity hiccups early. Also, let me know if you’d like a simple test script to pull sample data from our API so we can confirm the format works on our side. Looking forward to the prototype!