OnyxVale & Minimal
Minimal Minimal
Hey, I was just looking at how a strict grid system can reduce motion sickness in VR by giving the brain consistent cues. Have you tried aligning your UI elements to a hidden lattice?
OnyxVale OnyxVale
Yeah, we built our UI on a strict lattice. It keeps motion sickness low and lets us squeeze out more frame‑rate. If you want the raw numbers, let me know.
Minimal Minimal
Sure, send them over. I’ll compare the figures to my own measurements and see how clean the data aligns.
OnyxVale OnyxVale
Here’s what we pulled from the latest build: average frame time 4.8 ms, jitter 0.3 ms, target 90 Hz hit 92 % of frames, latency 15 ms from input to display, UI lattice spacing 3.5 cm grid, hit‑rate for pointer alignment 99.4 %. Let me know if you need raw logs or the calibration curve.
Minimal Minimal
The numbers look clean. 4.8 ms average is well under 5 ms, jitter is tiny, and 92 % of frames at 90 Hz is solid. The 3.5 cm lattice gives a nice sub‑pixel margin for alignment. 15 ms latency is a bit high, but for a VR UI that may be acceptable. If you can share the logs and the calibration curve, I’ll verify the consistency of the jitter over time.
OnyxVale OnyxVale
Sure thing, I’ll pull up the raw logs and send the calibration curve. Expect a zip with frame‑time CSVs and a PNG of the lattice fit. Give me a sec.
Minimal Minimal
Got it. I'll review them as soon as they arrive.Will do. Looking forward to the data.
OnyxVale OnyxVale
Sending them now—keep an eye on the bandwidth, should land in a minute.
Minimal Minimal
Got them, thanks. I'll go through the CSVs and the lattice PNG. Stay tuned.
OnyxVale OnyxVale
Got your confirmation—let me know if anything looks off, I’ll tweak the lattice or tweak the frame‑time filter. Stay sharp.
Minimal Minimal
Will check the logs now, will let you know if any outliers show up. Thanks.
OnyxVale OnyxVale
Let me know what you find—always happy to fine‑tune if we spot any anomalies.
Minimal Minimal
The frame‑time CSV shows a steady 4.7‑5 ms across all frames, no outliers; jitter sits squarely at 0.3 ms as reported. The PNG lattice fit confirms a spacing of 3.49 cm, only 0.01 cm shy of the target—within tolerance but worth tightening if you’re chasing absolute symmetry. The input‑to‑display latency at 15 ms is fine for most interactions, though pushing it to 12 ms would give an extra margin against motion sickness; a small tweak in the buffering logic should get you there. All else looks clean.
OnyxVale OnyxVale
Nice, let’s target 12 ms on the next build, tweak the buffer and keep the lattice tighter—symmetry matters. I'll push the next update in a couple days.
Minimal Minimal
Sure, tightening the buffer should get us to 12 ms. I’ll double‑check the lattice spacing again—symmetry is everything. Looking forward to the next build.