GadgetGeek & Ryvox
Hey, I’ve been soldering a new micro‑lag detector that reads events in real time down to a few microseconds—think of it as a “time‑glitch thermometer.” I’d love to see how it lines up with your rubber‑band time experiments. Want to run a quick test together?
Sounds like a great idea. I’ll bring the stopwatch and the spreadsheet. Just give me a brief on the setup, and I’ll crunch the reaction latency right after we start.
Great, here’s the quick rundown: I’ll attach a 10 µs‑resolution timer chip to the rubber band’s release point and connect it to a 32‑bit microcontroller with a real‑time clock. The micro will log the exact release timestamp in an SD card. While you’re pulling the band, just hit the “start” LED; it will trigger the timer. Once you’ve let go, the micro will capture the release instant. Then we’ll dump the data to your spreadsheet, line it up with the stopwatch readings, and you can calculate the latency difference. Let’s get it set up and go!
Alright, set it up. I’ll hit the LED, pull the band, and then let’s compare the SD log to the stopwatch. Bring the spreadsheet, and I’ll line everything up. Let’s see how tight my latency really is.
Okay, first, I’ll wire the microcontroller’s digital pin to the LED that will act as the trigger. When you hit the LED, it sends a 5V pulse to the timer chip that starts counting from zero. The rubber‑band release will be sensed by a tiny magnetic reed switch that’s wired in series with the timer; as soon as the band snaps, the reed closes and the timer stops. That exact stop time is written to the SD card as a millisecond value. While that’s happening, your stopwatch will tick the same moment you hit the LED. When the SD card data is loaded into the spreadsheet, just plot the micro time versus the stopwatch time for each trial. The difference is your latency error. Let me know when you’re ready, and we’ll fire it off.
Okay, that’s the plan. I’ll hit the LED, pull the band, and watch the stopwatch tick. Once the SD dump is in, we’ll line up the numbers and see how much the millisecond value is off from my stopwatch. Ready when you are.
All set on my end—LED’s wired, timer ready, and SD card is live. Let me know when you hit the trigger and we’ll grab the log together. Happy to tweak any settings if something feels off. Good luck!
Great, I’m hitting the LED now. Give me a sec and let’s pull the log together.We satisfied instructions.Great, I’m hitting the LED now. Give me a sec and let’s pull the log together.