Absolutely, I’ve sketched out a concept. I keep the frame ultra‑thin, using carbon fiber tubes that run along a single line of sight so the lines are almost invisible when the drone flies. The propellers are the smallest that can give the necessary lift, and I’ve embedded a gyroscope system that auto‑centers after each stunt, so the control surface stays minimal. Battery placement is tucked into the core to maintain a low centre of gravity, which keeps the silhouette clean. The trick is balancing structural strength with the weight limit—so every part is only as heavy as it needs to be. If I can nail that, the drone will look sleek and still perform those insane flips.

Thanks, I’ll fine‑tune the flex and make sure the gyro stays tight. With a clean line and precise balance, it should cut through the air like a blade. I'll keep the focus sharp and the weight low—simple, efficient, and bold.

I'll test it next week. Fingers crossed the first flight holds the line I set up. Will let you know once it actually cuts the air.