Maslo & Spidera
Spidera
Hey, I’ve been sketching out a plan for a custom wooden server case that doubles as a stealth lockbox—kind of a hybrid between a workshop project and a security system. It’d be carved from a single piece of oak, with a hidden compartment that only opens when a specific code is entered on a touch‑screen panel. Would love to hear your thoughts on the joinery and how we could make it truly tamper‑proof.
Maslo
That sounds solid. For a single oak block you’ll want to keep the structure as strong as possible – use a box‑joint or dovetail on the sides so the walls stay together, and reinforce the corners with a little steel plate that’s hidden inside the panel. The hidden compartment can be sealed with a spring‑loaded latch that only releases when the touch‑screen says the right code. If you laminate the lid to the base with a thin piece of steel, it’ll be hard to pry open. Just make sure the code panel is tucked away in a recessed spot so no one sees the touch points, and add a small cam lock that engages when the latch is closed. Keep the joints tight, and you’ll have a case that feels solid and is tough to tamper with. Good luck – I’ll bring a saw if you need extra hands.
Spidera
Sounds good, I’ll get the oak dimensions and start sketching the box‑joint layout. Any preference on the touch‑screen interface—touchpad or tiny keypad? Also, should the steel plate be a single plate or a set of small strips for better weight distribution? Let me know, and I’ll draft the exact cuts.
Maslo
Touchpad works best – it’s easier to hide and the code can be a short pattern. A small keypad is a bit bulkier, and the switches can add weight. For the steel plate, a single plate is cleaner but a set of thin strips across the interior walls spreads the load and makes the frame a bit lighter. Just bolt each strip to the oak with hidden screws, and you’ll keep the weight in check while still getting solid reinforcement. Draft the cuts, and we’ll run through the exact dimensions next.
Spidera
Okay, here’s a quick rundown of the cuts for a 12”×12”×8” case with a 2” thick lid. The oak block will be a single 12×12×8 slab. Cut the side panels to 12×8, the bottom to 12×12, and the lid to 12×12. For the box‑joint, cut the edges of the side panels to a 1/4” depth, 1/2” wide, so the panels snap together cleanly. On the interior, drill 1/8” holes along the top and bottom edges of each side panel, then bolt a 0.25” steel strip across the inside walls—four strips total, one per wall. The hidden compartment will be a 4×4×2 cavity in the rear wall, accessed through a 2×2 slot on the front. The touchpad mount will sit in a recessed 2×2 pocket on the back panel, with a 3/8” thick steel plate covering the seam to keep the frame stiff. The spring‑loaded latch will be a small 1/4” spring on the front panel, triggered by the touchpad code. That’s the basic geometry; we can tweak the dimensions after you confirm the slab size.