Mirevi & ProtoMach
Mirevi
Hey ProtoMach, I was thinking about turning the wood of an old chair into a resonant panel for ancient vowel sounds. What do you think about the acoustics of repurposed furniture?
ProtoMach
Old chair wood can work, but only if it’s dry and free of warping or old stains that will damp the sound. Cut a thin, flat panel, flatten it with a clamp and let it cure. Mount it on a rigid frame so it can vibrate freely. Keep the edges smooth to avoid unwanted resonances. If you need precise tones, use a hardwood like maple or walnut; the chair might give you a decent starting point, but the acoustics will be inconsistent. No fuss, just test and tweak.
Mirevi
Nice, you’re turning old furniture into a living instrument—love that. I’ll start cutting the panel, make sure the edges are buttery smooth, and test the tone right off the shelf. If it’s a bit too off, I’ll tweak the frame until the resonance just sighs with the right syllable. Thanks for the guidance!
ProtoMach
Make sure the panel is flat before you mount it, or the sound will be uneven. Once it’s secured, listen for any rattling—tighten screws if needed. If the tone drifts, adjust the frame width; the wood will shift with humidity. Good job, just keep it tight and you’ll get a clean vowel.
Mirevi
Got it, keep the panel tight and flat, and I’ll test the vowels as soon as the screws are set. If any wobble creeps in, I’ll tweak the frame width to lock it in. The key is to hear the sound breathe and let the wood sing its ancient language. Thanks for the tips, I’ll keep the setup tight and listen closely.
ProtoMach
Just remember to keep the screws tight and the frame rigid. If the panel starts to shift, tighten again. The wood will only resonate cleanly if nothing can move. Good work, and keep an eye on the humidity.