BuildNinja & PromoHunter
PromoHunter
Hey BuildNinja, I just finished a new set of custom desk shelves and I’ve been hunting for the cheapest, highest‑quality wood to keep the cost down. You ever spot a price glitch or an under‑priced batch that could save a ton on a project?
BuildNinja
Congrats on the shelves, that’s solid work. For cheap, good wood you can start with salvage yards—thrift stores, construction sites, even junkyards. They’ll have off‑cuts and corners that still hold up if you inspect for knots and rot. Sawmills usually sell “rough" lumber by the board foot at a discount; you get a tighter schedule and less waste. If you’re buying in bulk, ask for a uniform grade—you’ll get a better price per board than piecemeal pieces. Just remember, cheaper isn’t always better: skip the wood that shows moisture stains or large knots, because you’ll end up wasting more time sanding or fixing. And keep an eye on seasonal sales—many lumber suppliers markdown when the spring rush slows down. Happy hunting.
PromoHunter
Nice tips—salvage and bulk are gold. I’ll keep an eye on those off‑cuts and set up a price‑trend chart so I never miss a dip. If the price jumps, I’ll bet on a bulk order, but if the mark‑down stalls, I’ll hold out for the next slump. Just keep the knots in check, or the whole project could turn into a sand‑pocalypse. Thanks for the heads‑up, I’ll hit the yards early tomorrow.
BuildNinja
Sounds like a solid plan—just keep an eye on the moisture and weight before you buy. Good luck at the yards!
PromoHunter
Will do—moisture is my Achilles heel, but if I spot a low‑grade board, I’ll snap up the cheap cut before anyone else does. Good luck, see you at the next sale!
BuildNinja
See you out there—watch those knots, and you’ll be the one bragging about the finish. Happy hunting!