IronClad & Yuntric
IronClad IronClad
Yuntric Yuntric
IronClad IronClad
Alright, Yuntric, let’s design a smart stunt harness that keeps you safe on the edge but still lets the crowd scream. What’s the first component you think we should nail?
Yuntric Yuntric
First off, we need a sensor‑laden safety release—something that locks the harness in place until the rider hits the peak adrenaline point, then pops free just in time for the scream. That’ll keep the crowd on the edge and give me the margin to pull off that jaw‑dropping spin.
IronClad IronClad
Sure thing, Yuntric. Lock it with a dual‑stage latch: a primary mechanical hold that only disengages when an accelerometer spikes past a set threshold, then a secondary micro‑servo that gives the final pop‑free. Make the whole thing run on a single 3.7 V Li‑Po and back it up with a low‑power watchdog so you don’t get a surprise “no‑release” at the apex. And don’t forget a quick‑disconnect cable for the crew to yank it out in case of a mis‑calculation. Let's get that prototype wired.
Yuntric Yuntric
Sounds killer—dual latch with a brain on it, and a 3.7 V battery that’s light enough to stay in the pack. Watchdog’s a lifesaver, trust me, I’ve seen too many “no‑release” moments. Quick‑disconnect for the crew? Absolutely, gotta keep the crew laughing, not screaming. Let’s fire up that prototype and get the first test run. The crowd’s already waiting for the buzz.
IronClad IronClad
Great, Yuntric. Wire the accelerometer to the latch circuit, feed it through the watchdog, and mount the battery in the pack—keep it under 200 g. Run a quick spin in the empty rig first to tune the release threshold. Once it pops cleanly, we’ll fire it up on stage. The crowd will know the only thing louder than the scream is the precise timing of that release. Let's make it happen.
Yuntric Yuntric
Alright, let's crank that sensor up to peak, set the threshold for a perfect pop, and run a silent test spin—no crowds, just me and the rig. Once it’s timing on point, we’ll pull the trigger on stage. The crowd’s gonna feel the rush of the release before they even hear the scream. Let's get this show rolling.
IronClad IronClad
Set the accelerometer to zero, bump the threshold up by 20 %, spin in the simulator. When the latch disengages cleanly, mark the trigger point. Then we’ll lock the stage harness and let the crowd feel the rush before the scream hits. Ready to hit that trigger?
Yuntric Yuntric
Zeroed out and threshold bumped. Spin done—latch popped clean, trigger point locked in. Stage harness ready, crowd’s breathing it in. Let's hit that trigger and let the rush start. Bring it on!
IronClad IronClad
Nice. Keep the harness tight, the trigger set, and let the audience feel the jump before the scream. Time it, hit the button, and make that release count. Let’s go.
Yuntric Yuntric
Here we go—feel the surge, release engaged, crowd’s about to scream. Let’s do it.
IronClad IronClad
Got it. Release now, let the surge hit, then go. Let’s make that scream unforgettable.