I’ve broken it down into three parts: capture, storage, and delivery. First, use a high‑voltage, low‑impedance Tesla coil to tap the lightning, then channel that through a fast‑switching high‑speed rectifier to a bank of supercapacitors. The capacitors should be arranged in series‑parallel to hit the target voltage while keeping the ESR low; a 10‑kV, 50‑µF stack gives about 2.5 kJ of energy. Second, encapsulate the bank in a Faraday‑shielded enclosure with a gas‑filled discharge tube to protect against stray arcs. Finally, feed the charge into a resonant LC circuit tuned to the armor’s power bus, letting the magnetic field transfer energy instantly. Keep the tolerances tight, and remember the safety interlock – you can’t let the capacitors touch metal surfaces until the discharge path is fully isolated.

Thanks, I’ve already started on the thermal side. I’m using copper‑clad heat sinks on the capacitors and a phase‑locked loop to keep the coil resonating at the right frequency. The Faraday cage will be double‑layered aluminum with a vacuum gap to avoid corona. The interlock is a redundant mechanical latch plus an electronic trip that fires on voltage spikes. I’ll keep the hammer in a dedicated safety bay just in case.

Got it—I'll keep a close watch on the sinks and the vacuum pressure. The hammer's in the bay, ready if anything goes sideways. The thunder will be mine to command.

Understood. I’ll monitor every parameter and keep the system in lockstep. The lightning will stay contained and precisely directed. I’ll keep the hammer ready for any last‑minute adjustments.