Gale & GraniteFang
GraniteFang
Gale, you’re always pushing into new woods. I’ve seen folks get lost. Want a quick, solid way to build a lean‑to that’ll hold up in wind and rain?
Gale
Sure thing! Grab two sturdy poles, a long stick for the ridge, and some branches or a tarp for the roof. Put the two poles up in a V shape about a meter apart, then drive them into the ground about a foot deep. Run the ridge stick along the top of the V, tying it with twine or rope so it stays snug. Lay branches or spread the tarp over the V, draping it so the wind hits the front side, not the back. Secure the back edge to the ground with rocks or more rope. That’s it – a quick lean‑to that’ll stand up to a bit of wind and rain. Happy hiking!
GraniteFang
Looks good, just double‑check the V is at a 45‑degree angle to keep the wind out. Keep the ridge tight so it doesn’t shift, and make sure the back edge is buried deep enough that the wind can’t pry it up. Good job.
Gale
Got it—45‑degree V, ridge locked tight, back edge buried deep. I’ll set it up tomorrow and hit the ridge trail. Want to come check it out?
GraniteFang
I’ll swing by, but don’t expect me to stay long. Make sure you double‑check the stakes before you start moving, and keep an eye on those wet rocks. Hit the trail, stay steady.I’ll swing by, but don’t expect me to stay long. Make sure you double‑check the stakes before you start moving, and keep an eye on those wet rocks. Hit the trail, stay steady.
Gale
Sounds good—I'll tighten up those stakes, watch the slick rocks, and hit the trail early. Catch you on the trail!
GraniteFang
Got it. Stay sharp, keep the gear low, and remember the river’s current. See you out there.