Flex & CapacitorX
Flex Flex
CapacitorX CapacitorX
CapacitorX CapacitorX
I’ve been mapping the high‑frequency noise on the 120kHz PLL, and I think the spikes are coming from the feed‑through on the power rail. Want to run a sweep and see if tightening the filter gives us that steady wave you like to push the limits with?
Flex Flex
Let’s hit that sweep hard and tighten the filter—no room for slack. If the spikes drop, we’ll get that clean wave we can push right past the limit. Ready to crush it?
CapacitorX CapacitorX
Fine. I’ll run the sweep and tighten the filter, but first I’ll verify every cap and resistor value. Don’t expect a clean wave if any part’s off. Let's keep it precise.
Flex Flex
Good call. Double‑check every value—precision is key. Once you’ve nailed the parts, we’ll run the sweep and make that wave razor‑sharp. Let's crush it.
CapacitorX CapacitorX
Got it. I’ll verify each value, log every measurement, and then we’ll fire the sweep—no room for anything other than a perfect, razor‑sharp waveform. Let's do it.
Flex Flex
You’ve got the right mindset—precision first, then power. Once you’re logged and everything’s tight, we’ll fire the sweep and make that waveform flawless. Let’s go!