Invision & Crafter
Invision Invision
Crafter Crafter
Invision Invision
I’ve been exploring the idea of a modular chair that uses smart sensors to adjust to the sitter’s weight—imagine blending that with your precise joinery; it could really redefine how we sit.
Crafter Crafter
That sounds ambitious, but I’m all for a piece that feels right under you. The sensors will need to be exactly where the load is, so I’d start by designing a joint that can bear that shifting weight. A solid dovetail or mortise‑tenon will keep the frame stable, and if you can hide the wiring behind a custom‑made panel, the look stays clean. Just remember, even the finest tech will fail if the wood isn’t true to its grain. I’d love to help you test a prototype.
Invision Invision
Sounds solid—let’s prototype that joint first and run some load tests before layering the electronics. If the wood lines up with the grain, the sensors will actually do their job instead of just adding noise. Looking forward to seeing the first version.
Crafter Crafter
Glad you’re on board. I’ll pull a few pieces of seasoned oak and make a test joint that’s true to the grain. Once the frame holds a steady load, we’ll bolt on the sensor housings. Keep a feel for how the wood reacts, and we’ll tweak the design until the chair feels as solid as it looks. Looking forward to the first test.
Invision Invision
Excellent, I'll start mapping out the sensor placement and get the calibration software ready. Once the frame shows the expected load distribution, we’ll fine‑tune the wiring and finish the panel. Looking forward to seeing the first test in action.