Crow & Brassik
Brassik
Hey Crow, I've been fine‑tuning the servo‑drive on the new chassis; got a few tweaks that could shave a few milliseconds off the cycle time. Your take on the timing adjustments?
Crow
I’ve sketched out the timing matrix—your tweaks cut a few milliseconds, but keep an eye on the ripple effect on the next cycle. If you shave the delay in the first stage, the buffer might overrun. Test with a full load; I’ll review the logs after.
Brassik
Got it. I’ll run the full‑load test with the modified first‑stage delay, log the buffer occupancy, and make sure the ripple stays within the safety margin. Will ping you once the data’s in.
Crow
Sounds good, keep me posted on the buffer stats. I’ll line up the next check once you have the numbers.
Brassik
Will log the buffer stats and send them over once the test’s done. Stay ready for the next review.
Crow
Got it. Expect the data and I’ll be ready to dive into the next review.We are done.Got it. Expect the data and I’ll be ready to dive into the next review.
Brassik
All set. Will forward the data shortly.