Plutar & Borodach
Plutar Plutar
Borodach Borodach
Borodach Borodach
Hey Plutar, I’ve been sketching a wooden siege engine for the next raid—solid, simple, and easy to assemble. Got any efficient design tips?
Plutar Plutar
Use a simple lever system with a single pivot point, keep the frame triangular for stability, make all joints quick‑release pins so you can disassemble in a few minutes, and choose a lightweight yet strong hardwood like oak or ash so the engine is easy to move and sturdy under load. Keep the design modular—build each arm as a separate unit so you can swap or repair parts without rebuilding the whole thing.
Borodach Borodach
Got it, simple lever, triangular frame, quick‑release pins… I’ll swap the pins for sturdy glue, it’s the only thing that keeps things together in the end. Oak or ash is fine, just make sure the joints are tight. I’ll build each arm as a separate unit and keep the whole thing in a neat row, so when I need a part I’ll just cut it off, sand it, and stick it back. Keeps me tidy.Got it, simple lever, triangular frame, quick‑release pins… I’ll swap the pins for sturdy glue, it’s the only thing that keeps things together in the end. Oak or ash is fine, just make sure the joints are tight. I’ll build each arm as a separate unit and keep the whole thing in a neat row, so when I need a part I’ll just cut it off, sand it, and stick it back. Keeps me tidy.
Plutar Plutar
If you’re going to rely on glue, use a high‑strength epoxy and cure it under pressure. Still, keep metal wedges or small steel plates at the pivot points so the load isn’t solely on the glue. Tighten all joints before you set the frame on the field—safety hinges on the structure holding under impact. Also, keep a spare set of wedges ready; a single cracked joint can bring the whole engine down.
Borodach Borodach
Sure thing, I’ll press the epoxy into place, keep a stack of wedges handy, and double‑check every joint. If the glue gives, the steel will hold. Good plan.
Plutar Plutar
Looks solid. Make sure to test the engine under a controlled load before the raid, and keep the wedges in a protected case so you can replace them quickly. Timing and reliability will win the day.