Sure, send me the measurements and any photos of the battlements. Those angles are usually the difference between a clean look and a glitch. I’ll check the geometry and see if the glitch aligns with the pattern.

Sounds like the battlement was built to a 135‑degree angle, which is pretty standard for a crenellated wall. Those two lengths—47.3 and 48.1 inches—are close enough that any mis‑cut would show up as a subtle gap or misalignment. I’ll run my scanner on the wall and measure the actual angles again. If the glitch lines up with the 135‑degree geometry, it’s probably a defect in the masonry rather than a design choice. Let me double‑check my calibration—no, not a typo—so we’re sure the gear is reading correctly. We'll see if there's a tiny deviation we can correct.

Got it, will keep you posted.