Sounds like a fun project, but you’ll need to get into the weeds if you want that live‑concert vibe without the mess. Start with a pair of small, high‑efficiency floor‑standing speakers that have a good 20‑Hz to 20‑kHz range and a bit of a bass boost. Pair them with a compact digital‑to‑analog converter that can handle at least 24‑bit/96‑kHz audio so you’re not capping quality at the source. Use a small, rack‑mounted or desktop amp that’s got clean gain stages and a low‑noise preamp. The key is to keep the signal path straight: source, DAC, amp, speakers. If you want Bluetooth, stick to a certified class‑1 device with a low‑latency codec so the delay won’t make you feel like you’re listening to a recording. For assembly, think modular. A slim, detachable power block for the amp, a quick‑connect cable set for the speakers, and a single cable for the DAC to the amp. Maybe even a small, pre‑wired Bluetooth adapter that plugs into the DAC’s USB port. That way you set it up, plug in a power cord, and you’re ready to go. Acoustically, place the speakers on sturdy stands a few feet apart, slightly angled toward the listening area. A bit of foam behind them will cut off reflected sound and give you that “stage” clarity. If you’re worried about portability, make the stands collapsible and the cables detachable so you can pack everything into a case. Keep the design simple, but don’t skimp on the cable quality. Shielded cables with gold‑plated connectors keep interference low and preserve the fidelity. And remember: the best sound system is the one that’s actually used, not just the most technical. So test it in a real room, tweak the EQ a little, and you’ll have a portable concert experience that feels great and is easy to set up.